Universal R-320 Instrukcja Operatora Pobierz pdf (Strona 12)

SETUP AND OPERATION CONTINUED

ADJUSTING THE TURNING UNIT

1. To do this, loosen the knobs under the Turning Unit. Move the Turning

Unit to the desired position and re-tighten the knobs. (See Fig.8)

2. The turning unit needs to remain at a slight decline, relevant to the

product flow, to the top of the conveyor (Ref. Fig. 8a). If the turning

unit is inclined, the container will want to rise up off the conveyor,

which will wrinkle or cause skewing to the label. Excessive decline will

wrinkle the label or cause the label to be skewed (1/16” – 1/8” is

recommended). Determine if the turning unit needs to be adjusted.

Then loosen the (8) 10-32 socket head cap screws that secure the (4)

backing plate guides. Adjust the turning unit until container runs true.

With your fingers, squeeze the backing plate guides up against the unit

mounting posts and re-tighten the screws that secure them. (See

Fig.8)

Fig.8

Turning Unit

Knobs

Backing

Plate Guide

Unit Mounting

Post

10-32 Socket Head

Cap Screw

Fig.8a

-1/16”- 1/8”

PRODUCT FLOW

Conveyor

Top

Turning Unit

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 68 69

Brak uwag

Universal R-320 Instrukcja Operatora Strona 12